Build A Two-In-One Shed

Read full article here...

 

Here's a handsome Colonial-style storage shed that's one of the most versatile, well-designed backyard buildings we've seen. In fact, it's really two sheds in one: a 10 x 12-ft. toolshed for general storage and an 8 x 10-ft. open-bay extension that's ideal for keeping firewood stacked and dry. The extension is also great for storing large items that might not easily fit into the main shed, such as lawnmowers, bicycles, patio furniture, wheelbarrows and stepladders.

We built our combination shed on a 4-in.-thick concrete slab, which makes an extremely durable and weatherproof floor. You could also construct a wood-frame floor using pressure-treated 2 x 6 lumber and a plywood deck, and support the assembly on solid concrete blocks or pressure-treated 6 x 6 skids. If you go with the slab, it's a good idea to hire an excavator and mason to have the job done right. Place anchor bolts in the concrete for securing the walls, taking care to avoid vertical frame locations and wall openings.

We sheathed the structure with 1 x 6 tongue-and-groove cedar siding, which is naturally resistant to rot and insects. The roofs are covered with slate-gray, architectural-style asphalt shingles. Perforated-aluminum soffit vents installed along the eaves and continuous ridge vents at the peaks help exhaust hot air that can build up under the roofs during warm summer weather.

The main shed has three tilt-in barn-sash windows and a door that's made from the same tongue-and-groove 1 x 6 cedar used for the siding. You're not likely to find barn-sash windows at a home center, but they can be special-ordered at most lumberyards and farm-supply outlets.

You can buy detailed plans for the combination shed for $29.95 from Better Barns Betterbarns.com . Request plans No. 2023. The company also offers the traditional-style strap hinges and door latch we used.

START AT THE TOP
Before building the walls, make use of the open floor space as a platform for building the roof trusses. Each truss consists of two 2 x 4 rafters and a 2 x 4 chord that also acts as a ceiling joist. At the corners are plywood gussets secured with construction adhesive and roofing nails.

Note that the gable trusses have collar ties (short horizontal members) so there's extra wood to which you can nail the siding. When you build the gable trusses, add flat 2 x 4 pieces, or shoes, to their bottom chords so the gables can be set slightly proud of the walls below them.

Both roofs have a 10-in. pitch--the slope rises 10 in. for each horizontal foot. This creates 50-degree angles at the rafter and chord ends. To cut these with a circular saw, use a template of the angle to mark each piece. If you're using a power miterbox, the angle graduations are complementary--you'll get a 90-degree cut when the tool is set at 0 degrees. So, set the tool at 40 degrees to end up with a 50-degree angle.

 

Read more about wooden storage buildings